PUKKLAAGER d-90mm UCP 218 -SKF-

312,23 € (sis. KM)

2 laos (Laki 26)

Pukklaagriüksus pikendatud siserõnga ja kruvilukuga, malm, Jaapani standardid
Üksused koosnevad malmkorpusesse paigaldatud laagrist, mida saab poltidega kinnitada tugipinnale. See variant on tugev ja jäik ning sobib kasutamiseks nii pideva kui ka vahelduva pöörlemissuunaga. Sellel on mõlemalt poolt pikendatud sisevõru ja see lukustatakse võlli külge, pingutades sisemise rõnga kinnituskruvisid, muutes selle paigaldamise lihtsaks.

Tootekood: UCP 218 Kategooriad: ,

Kirjeldus

UC-r200/300 seeria_pdf

UCP 218
Pillow block ball bearing unit with extended inner ring and set screw locking, cast iron, Japanese standards
Pillow (plummer) block ball bearing units consist of an insert bearing mounted in a cast iron housing that can be bolted to a support surface. This variant is strong and stiff, and is suitable for applications with both constant and alternating directions of rotation. It has an inner ring extended on both sides and is locked onto the shaft by tightening a set screw on the inner ring, making it easy to mount.
Strong
Designed for a constant and alternating rotation
Ready to mount
Lubricated and sealed bearing
Quick locking onto the shaft
Cost-effective

DIMENSIONS
Bearing width, total 96 mm
Centre distance of bolt holes of pillow type, square and oval flange type housing 262 mm
Centre height (pillow block) 102 mm
Housing overall width 88 mm
Pitch diameter of bolt holes of round and triangle flange type housing
Shaft diameter 90 mm

PERFORMANCE
Basic dynamic load rating 95.6 kN
Basic static load rating 72 kN
Limiting speed 1600 r/min

PROPERTIES
Bore type Cylindrical
Coating Without
Fastening bolt hole type Plain
Flanged housing type
Housing type Pillow (plummer) block
Lubricant Grease
Material, bearing Bearing steel
Material, housing Cast iron
Number of bolt holes for fasteners 2
Relubrication hole With
Relubrication nipple With
Retaining feature, inner ring Set screws
Rubber seating ring Without
Sealing type Contact
Sealing, bearing Seal and flinger on both sides
Sealing, unit Without

Pillow block ball bearing unit with extended inner ring and set screw locking, cast iron, Japanese standards
Pillow (plummer) block ball bearing units consist of an insert bearing mounted in a cast iron housing that can be bolted to a support surface. This variant is strong and stiff, and is suitable for applications with both constant and alternating directions of rotation. It has an inner ring extended on both sides and is locked onto the shaft by tightening a set screw on the inner ring, making it easy to mount.
Strong
Designed for a constant and alternating rotation
Ready to mount
Lubricated and sealed bearing
Quick locking onto the shaft
Cost-effective

Sulle võib meeldida ka…